We recommend you to place the order in our new online store:
Colors shield is a RGB LED matrix driver shield for Arduino, and you can use it as a starter edition Colorduino.
The Colors shield can directly plug on the Arduino board, and hook up with the RGB LED matrix, you can use the Arduino to drive the matrix like the Colorduino/Rainbowduino. The code of Colors shield is the same as Colorduino.
It’s use the 8×3 channel constant current LED driver chip DM163 to make the constant driving and PWM grayscale control. There is a 16M active crystal to provides the time signals.
Colors shield be designed to drive the RGB LED Matrix easily, just plug and shine – you don’t need to care about the circuit.
The Colors shield can be plug on the Arduino UNO/Duemilanove, so the controller is basis on ATMega 168P/328P, the same as Rainbowduino. This design is to make user easily modify or write the firmware of Colorduino by Arduino IDE. But in order to better drive the RGB matrix and reach their best performance, we use the professional LED driver chip, and this chip comprises shift registers, data latches, 8×3 channel constant current and 64 x 256 gray level PWM for per color! Each channel provide a maximum current of 60 mA.
Each RGB dot has 160K colors in theory, and it’s easy to use the 6bit correction register to calibrate the current error for each color LEDs – we don’t think that Rainbowduino use an adjustable resistors to calibrate the current error is a good idea, because just 1 lap the resistor change from 0R to1K , you cannot get the exact value you need, but now, you have a 6bit software value to correct it.
You can find the compatible RGB LED Matrix here:
60mm square 8*8 LED Matrix - super bright RGB (circle)
60mm square 8*8 LED Matrix - super bright RGB (square)
Schematic of Colors shield v1.1
Data sheet of DM163
Data sheet of Colors shield v1.1
Demo Code for Colors Shield v1.1
Ah, Colorduino Debut !
ITead Studio Colorduino
Colorduino Library v1.0